1500 Watt Inverter: 12V Mid-Load Power in a Work Van
Date:2026-11-20 Click:30 Source:Rogerele
Quick answer: A 1500 watt inverter such as the REP1500 pure sine wave inverter is rated 1500W continuous with a 3000W listed peak (peak duration is not specified). At full rated load and the listed maximum efficiency of 90% on a 12v inverter version, DC current is about 139A (1500W ÷ (12V × 0.90)). That current is far above what a cigarette-lighter socket can supply, so a work-van install must be hardwired. Keep simultaneous loads at or below 1500W.
The REP1500 is a dc to ac inverter for a matched battery bank. It is not a solar charge controller, battery charger or UPS transfer unit. A cigarette lighter is not a suitable supply.
What a 1500 watt inverter is rated to deliver
A 1500 watt power inverter in this series produces a pure sine wave with THD under 3% on a linear load, at 50Hz ±0.5Hz or 60Hz ±0.5Hz. AC voltage is ordered as 100 / 110 / 120V or 220 / 230 / 240V (±5%), as ordering options rather than a user-switchable setting on every unit. Listed maximum efficiency is 90% (12V), 92% (24V) and 95% (48V), and those maxima vary with load and conditions.
Plan against the 1500W continuous rating, not the 3000W listed peak. The peak figure is a short startup allowance only, with no published duration or motor-start test, so it does not by itself prove that a compressor, pump or tool will start. USB QC3.0 is listed on 12V and 24V versions only. Operating temperature is −10°C to +50°C, with intelligent air cooling. If the combined continuous load stays above 1500W, see the REP2000 pure sine wave inverter.
12V current: why a work van must be hardwired
A 12V, 24V or 48V unit in this family is a separate hardware code, not a mode on one chassis. The bank’s nominal voltage must match the inverter’s DC input. Listed battery-side operating ranges are 10–15.5V (12V), 20–31V (24V) and 40–61V (48V). Most work vans and cars use a 12V system, so check the 12V current figure before mounting a 1500w inverter.
| Model code | DC input | AC output ±5% | No-load current |
|---|---|---|---|
| REP1500-121 | 12V | 100 / 110 / 120V | <0.8A |
| REP1500-241 | 24V | 100 / 110 / 120V | <0.4A |
| REP1500-481 | 48V | 100 / 110 / 120V | <0.2A |
| REP1500-122 | 12V | 220 / 230 / 240V | <0.8A |
| REP1500-242 | 24V | 220 / 230 / 240V | <0.4A |
| REP1500-482 | 48V | 220 / 230 / 240V | <0.2A |
Battery current falls as voltage rises. The table estimates current at nominal voltage and listed maximum efficiency, using 1500W ÷ (voltage × efficiency). Real current is higher near cutoff or at lower efficiency, so cables, lugs and fuses must follow the wiring instructions, not this estimate alone.
| Version | Estimate at 1500W rated load |
|---|---|
| 12V at 90% efficiency | about 139A (1500W ÷ (12V × 0.90)) |
| 24V at 92% efficiency | about 68A (1500W ÷ (24V × 0.92)) |
| 48V at 95% efficiency | about 33A (1500W ÷ (48V × 0.95)) |
| Listed no-load, 12V / 24V / 48V | <0.8A / <0.4A / <0.2A |
A typical vehicle cigarette-lighter socket is limited to about 10–15A (around 120–180W at 12V). It cannot feed a power inverters 12v load of about 139A. For socket versus battery-cable connections, see hardwire vs cigarette lighter for a car power inverter. Request the current drawing and wiring instructions before freezing cable size, fuse rating and the mounting layout. The enclosure is 310 × 180 × 80 mm and 2.9 kg net; leave ventilation around the cooling fan and access to the DC terminals.
Plan mid-power work-van loads against the 1500W rating
Add every nameplate running watt that can be on at the same time and keep that total at or below 1500W. Startup current on compressors, pumps and some tools is a separate check: the 3000W listed peak has no published duration, so share the equipment’s starting data if a motor load is in the mix.
Worked example with nameplate figures you must confirm on the actual equipment, not as a factory test: a 700W microwave, a 150W fridge running wattage and a 120W laptop or tool charger total 970W if they run together, under the 1500W continuous rating. A 1500W kettle or heater uses the full rating by itself. Starting batteries are a poor source for a sustained 139A draw; plan an auxiliary bank and protection that matches the wiring instructions.
What features should a truck power inverter have?
For trucks and other power inverters for vehicles, start with a published continuous rating that covers the simultaneous load, a DC voltage code that matches the vehicle bank, and a sine wave inverter output if the load includes electronics, tools with motors or medical devices. The REP1500 lists THD under 3% on a linear load, intelligent air cooling, and low-voltage, over-voltage, overload and over-temperature protection, plus short-circuit indication and fuse operation for reverse polarity.
Confirm the outlet with the order. Official product photos show configuration examples, including a multi-format outlet, two US-style AC outlets, and UK-style, Schuko-style, South African-style and Australian-style options; availability is confirmed per quotation. A front-panel LCD appears on the published photographs. USB QC3.0 is listed only on 12V and 24V versions. Remote control is not listed on the REP1500 product page. Custom DC inputs of 36V, 60V, 72V, 84V and 96V are listed as project options, confirmed per quotation.
| Version | Low-voltage alarm | Low-voltage cutoff / recovery | Over-voltage cutoff / recovery |
|---|---|---|---|
| 12V (10–15.5V) | 10.5 ±0.5V | 10 ±0.5V / 12.3 ±0.5V | 15.5 ±0.5V / 14.8 ±0.5V |
| 24V (20–31V) | 21 ±0.5V | 20 ±0.5V / 24 ±0.5V | 31 ±0.5V / 29.5 ±0.5V |
| 48V (40–61V) | 42 ±1V | 40 ±0.5V / 48 ±1V | 61 ±1V / 59 ±1V |
Match the pack’s charge voltage and BMS cutoff to those windows before ordering. The REP1500 converts DC to AC; it does not charge the battery, and a solar array should not be wired as if the inverter controlled charging.
Where can I find a reliable car inverter factory in China?
Wenzhou Rogerele Electronic Technology Co., Ltd is a manufacturer in Yueqing, Wenzhou, Zhejiang, integrating R&D, production and sales of pure sine wave inverters, including the REP1500. The factory address is No. 8-88 of Xingye North Road, Youli Industrial Zone, Liushi Town, Yueqing, Wenzhou, Zhejiang Province. Direct factory inquiries go through the contact page. Include the company name, destination market, vehicle application, load list, battery voltage, AC voltage and frequency, outlet type and quantity.
The company profile states that products have passed CE, RoHS and FCC export documents. Request the files that apply to the exact model and destination. The listed warranty is 2 years; confirm coverage and service terms in writing. Samples, minimum order quantity and lead time are confirmed per quotation. Packing is listed as 345 × 230 × 130 mm per unit, 2.9 / 3.4 kg net / gross, six pieces per 490 × 360 × 440 mm carton at 20.4 kg gross.
FAQ
Which companies offer wholesale automotive power inverters?
Rogerele supplies the REP series, including the REP1500, from its factory in Yueqing for wholesale and equipment-integration orders. Name the model codes, DC voltage versions, AC voltage, frequency, outlet, destination, quantity and expected repeat demand. Branding and carton marks can be reviewed with the quotation. Minimum order quantity and lead time are confirmed per project.
Which inverter manufacturers offer competitive factory-direct pricing?
Factory-direct prices are not published on the product page, because they depend on model code, outlet and voltage configuration, quantity, documentation, branding and packing. Compare published ratings, protection thresholds, packing data and destination documents, then request a quotation with the load list and annual volume.
How do I contact a direct automotive inverter manufacturer?
Use the Rogerele contact page and include company name, destination, application, model code, DC input, AC voltage and frequency, outlet, quantity and required documentation. Add branding or packaging requirements where they apply. Sample availability is confirmed per quotation.
Can I power a 1500 watt inverter from a cigarette lighter?
No. At 1500W and the listed 12V maximum efficiency, estimated battery current is about 139A. A cigarette-lighter socket is typically limited to about 10–15A and is not a suitable supply. Hardwire to a battery that can deliver that current, with cables and protection from the wiring instructions.
Does the 3000W peak rating mean a 1500W inverter can start any motor?
No. The published peak figure has no duration or startup test condition. Provide the equipment and starting characteristics for a suitability review. Keep combined continuous loads at or below 1500W.
Conclusion
Specify a 1500 watt inverter by continuous load, DC voltage version and the current the battery and cables must carry. The REP1500 pure sine wave inverter publishes those electrical figures: 1500W rated, 3000W listed peak, six 12V / 24V / 48V codes, about 139A / 68A / 33A at full load under the conditions above, and a 310 × 180 × 80 mm, 2.9 kg enclosure. For samples, private-label markings or a wholesale quotation from Wenzhou Rogerele Electronic Technology Co., Ltd, use the contact page.
